ELECTRICAL AND ELECTRONICS - Engineering and Science Online Tests
Question 1: An intrinsic semiconductor at the absolute zero temperature ...

Question 1: Intel 8085 is manufactured using ...

Question 1: The junction capacitance of a p-n junction depends on ...

Question 1: A'+B'+C'=D represents a ...

Question 1: How much time is required for an operating 100 W light bulb to dissipate 10 Joules of electrical energy? ...

Question 1: The increasing order of input resistance of the op-amp's with various types of transistors is ...

Question 1: The formula of heat produced in a wire of resistance R when a current of I ampere flows in it for t seconds? ...

Question 1: The number of canonical expression that can be developed over a 3-valued boolean alzebra is ...

Question 1: In maximum mode of operation of 8086,which bus controller is used to issue control signals? ...

Question 1: What logic function is obtained by adding an inverter to the inputs of an and gate ? ...

Question 1: The transformer oil should have______ volatility and ________ viscosity. ...

Question 1: A properly biased JFET will act as a ...

Question 1: 8051 is an........ ...

Question 1: Resistance in electrical circuit is equivalent to what in magnetic circuit ? ...

Question 1: With a NAND latch a low R and S produce a ....... condition. ...

Question 1: 2.s complelement of 010111.1100. ...

Question 1: ADDRESS BUS IS ___________BIT. AND DATA BUS IS________. ...

Question 1: A digital signal has a bit rate of 2000 bps. What is the duration of each bit? ...

Question 1: Which of the following waves has the highest value peak factor? ...

Question 1: IN GROUND WAVE PROPAGATION THE ABSORPTION OF WAVES ...

Question 1: Variable speed can not be obtained with ____. ...

Question 1: semiconductors are classified into ...

Question 1: A cascade IC is nowadays available for tuned PF and IF ampliefers.The significant feacture which makes it attractive is ...

Question 1: The metre is the length of the path travelled by light in vacuum during a time interval of __________ of a second." ...

Question 1: Air cored inductive transducers are suitable for use ...

Question 1: Total impedance of a series RLC circuit: ...

Question 1: With n nodes and b branches a network will have – ...

Question 1: A make break switch is provided to disconnect the battery when the meter is not in use in ...

Question 1: The memory addressing capacity of Pentium is ...

Question 1: A reading is recorded as 23.90 degree celsius.The reading has ___ significant figures. ...

Question 1: The time required for a gate or inverter to change its state is defined as ...

Question 1: For a PN junction the collision of carriers with crystal ions results in ...

Question 1: The clock frequency of 80486 microprocessor is about ...

Question 1: An undamped 2nd order system instrument has a natural frequency of 500 Hz. It is subjected to a sinusoidal input of unit amplitude at 500 Hz. The amplitude of output is ...

Question 1: __________ determines the rating of capacitance connected in each step during the first hour of its operation and stores them in memory. ...

Question 1: DWDM stands for______________________________. ...

Question 1: A d’arsonval galvanometer uses a light and scale arrangement.The light source is placed 1 m away. From the moving system of galvanometer.The arrangement used is a circular scale calibrated in mm.The deflection indicated by the scale is ...













